36
Chapter 2
Card access lamp
Chapter 2
Quick-start guide
Point the camera towards a
subject while viewing through the
viewfinder.
2
To focus on the subject, press the shutter
button halfway, slowly and gently.
● When the subject is in focus, the green
lamp lights up. If the green lamp is
flashing, the subject is not in focus.
Release the shutter button and repeat
step 3. If the camera still cannot focus,
see page 63.
To start shooting, press the shutter button gently all the way (fully).
● If the flash is up, it will fire automatically when required (P. 78).
● The card access lamp blinks and the camera begins storing pictures on
the card.
Taking still pictures
Remove the lens cap. Set the mode dial to and
press the POWER switch.
1
3
4
● Never open the card cover, remove the batteries, or disconnect an optional
AC adapter when the card access lamp is blinking. Doing so could destroy
stored pictures and prevent storage of pictures you have just taken.
To Next Page
Loading...
