Olympus DS-5500 - Using online help

50
4
EN
Connecting to your PC
Connecting to your PC
Connecting to your PC using the USB cable
1 BootthePC.
2 ConnecttheUSBcabletotheUSBportofthePC.
3 ConnecttheUSBcabletotheconnectingterminalonthe
bottomoftherecorder.
• [Remote(Composite)]isdisplayedontherecorderiftheUSBcableis
connected.
AfterconnectingtherecordertoyourPC,itwillbepoweredthroughtheUSB
cable.
WhenconnectedtoaPC,thebuilt-inmemoryandSDcardwillberecognized
bythePCasseparateremovablediskdrives.
Notes
• NEVERremovethecardordisconnecttheUSBcablewhilethestatus
indicatorlightisflashing.Ifyoudo,thedatawillbedestroyed.
• SomePC’smaynotsupplysufficientpowerandtherecorderfailsto
connect.RefertoyourPCuser’smanualregardingtheUSBportonyourPC.
• DonotconnecttherecordertoaPCbyusingaUSBhub.Makesureto
connecttoaUSBportonyourPC.
• Makesuretopushthecableconnectorallthewayin.Otherwise,the
recordermaynotoperateproperly.