Olympus EndoCapsule - Chapter 3 Installation and Connection of the Workstation

52
Chapter 3 Installation and Connection of the Workstation
OLYMPUS CAPSULE ENDOSCOPE SYSTEM
Chapter 3 Installation and Connection
of the Workstation
• Use the workstation in the configuration shown in the
“System chart” on page 244. Use of a workstation in any
other configuration may cause patient and/or operator injury
or equipment damage, and may impair the functionality of the
system.
• Before use, thoroughly review chapters 3 and 4 of this
instruction manual, as well as the instruction manuals
provided with the peripherals. If the equipment is not properly
prepared before each use, equipment damage, patient and
operator injury, and/or fire may result.
• Do not place the workstation and its peripherals (including
the recorder unit cradle) in the patient environment. Electric
shocks and, burns may result.
• Avoid placing the equipment in locations with the following
conditions. Failure to do so may result in malfunction of
and/or damage to equipment.
− Exposure to water.
− Exposure to rapid changes in temperature.
− Exposure to direct sunlight.
− Proximity to heat sources.
− Proximity to equipment that generates high frequency
waves.
− Exposure to high humidity.
− Exposure to significant vibration, or dust, lampblack, or
smoke.
• Use in a combustible atmosphere is prohibited.
The system is not explosion-proof, and may cause an
explosion or a fire.
• When turning the system OFF, follow the proper shutdown
procedure.
Failure to do so may result in equipment damage.