40
Slide the channel port grip in the direction of arrow 2.
This should accommodate the protrusions in the cut area.
Rotate the lock ring in the direction of arrow 3. to clamp the channel port grip. Confirm
that it is attached firmly.
Lock ring
If the channel port grip cannot be attached or removed because the lock ring
cannot be turned, stop using the equipment and contact Olympus.
Attach the remote control unit on the remote control unit mount of the channel port grip.
The remote control unit can be attached in either direction with respect to the channel port.
{ Removing the channel port grip and the remote control unit
When removing the remote control unit and channel port grip from the channel port grip
reverse the above steps.
3
To Next Page
Loading...
