Olympus OEV261H - Connecting to Power Supply

20
Chapter 3 Installation and Connection
High definition LCD monitor OEV261H
Chapter 3 Installation and Connection
Review this chapter thoroughly before each use. If the
equipment is not properly prepared before each use,
equipment damage, patient and operator injury and/or fire
can occur.
• Turn OFF all system components before connecting them.
Otherwise, equipment damage can result.
• Use appropriate cables. Otherwise, equipment damage or
malfunction can result.
• Use the monitor under the conditions described in the section
“Transportation, storage, and operation
environment/specifications” in the Appendix. Otherwise,
improper performance, compromised safety and/or
equipment damage may result.
• The cables should not be sharply bent, pulled, twisted or
crushed.
• Should the LCD panel of the monitor break, never touch it
with bare hands; injury could occur. If your hands come in
contact with the liquid crystal material, be sure to rinse them
off thoroughly with water.
• The HDTV monitor remote cable (MAJ-1161, MAJ-1230) is
connected to a “GPI” terminal. If this is connected to a
“RS-232C” terminal, it may lead to malfunction or equipment
damage.
Prepare this monitor and compatible equipment (shown in the “System chart” in
the Appendix) before each use, and refer to the instruction manuals of each
system component. Install and connect the equipment as following pages.