Chapter 6 Submenu Operations
63
High definition LCD monitor OEV261H
Submenu Description
MENU POSITION Positions the menu.
Menu position can be changed to one of the following positions.
• (default value)..................... Center of the screen
• ............................................ Top left of the screen
• ............................................ Top right of the screen
• ............................................ Bottom right of the screen
• ............................................ Bottom left of the screen
STATUS DISPLAY Determines the time that information on input changes and signal input format information
is displayed.
• CONTINUE.................................... Always on
• 3SEC OFF (default value) ............. A status change is displayed for about 3 seconds
and then goes off.
• OFF ............................................... Not displayed
∗
The status display ( , ) is always on in FLIP mode also when 3SEC OFF is set.
∗ The status display is always on when no input (NO SIGNAL) and input of an
unsupported signal format (UNSUPPORT SIGNAL) in PIP or POP mode even when
3SEC or OFF is selected.
POWER ON SETUP Selects the settings used when the monitor is turned on.
• LAST (default value)...................... Starts up in the settings used before the power was
last turned off.
• FACTORY...................................... Starts up in the factory default settings.
• PRESET A – J............................... Starts up using one of the preset A to J values.
• USER 1 – 20 ................................. Starts up in one of the recorded USER 1 – 20
values.
This menu does not change when the power is turned on.
POWER SAVE MODE Sets the power save mode.
• OFF (default value) ....................... Power save operation is not activated.
• ON ................................................. The backlight dims when no signal (NO SIGNAL)
lasts 60 seconds or longer. Signal input or front
panel operation will restore the backlight to its
normal brightness.
To Next Page
Loading...
