Olympus OEV261H - Transportation, Storage, and Operation Environment;Specifications

Chapter 6 Submenu Operations
65
High definition LCD monitor OEV261H
Submenu Description
FUNCTION1 Selects a function to assign to the FUNCTION1 button.
• AUTOSETUP...Performs auto setup of a PC display.
*3
• PORT A MONO...Selects monochrome for the PORT A screen.
*1 *3 *4
OFF → ON → OFF...
• PORT B MONO...Selects monochrome for the PORT B screen.
*1 *3 *4
OFF → ON → OFF...
• FLIP...Switches the display.
*1 *2 *3
Original image → Upside-down image → Reversed image...
• PORT A GAMMA SELECT...Switches the gamma mode of the PORT A screen
*1 *3
ENDOSCOPE → 1.8 → 1.95 → 2.0 → ...
• PORT B GAMMA SELECT...Switches the gamma mode of the PORT B screen
*1 *3
ENDOSCOPE → 1.8 → 1.95 → 2.0 → ...
• POP DISPLAY POSITION...Selects the position of PORT A/B display in the POP mode.
*1 *3 *5
MODE1 → MODE2 → MODE1...
• UNDEF...Indicates no function has been assigned.
Default value: PORT A GAMMA SELECT
FUNCTION2 Selects a function to assign to the FUNCTION2 button.
FUNCTION2 allows you to assign the same functions as FUNCTION1.
Default value: PORT B GAMMA SELECT
FUNCTION
DISPLAY
Sets the information displayed when the FUNCTION1 – 2 buttons are pressed.
Settings that are being changed appear in green.
• OFF ............................................... Does not display assigned function. (Displays operating
status.)
• ON1............................................... Displays the assigned function when the FUNCTION
button is pressed, executes this function and displays
the operating status of this function.
• ON2 (default value) ....................... Displays the assigned function and its operating status
when the FUNCTION button is pressed.
Pressing the FUNCTION button again when the assigned function is displayed executes the
assigned function.
∗1: Changes in settings change menu settings.
∗2: These functions are disabled when the control settings are in GPI mode.
∗3: When the same INPUT is selected for both PORT A/B, both PORT A/B comes available.
∗4: When signals input via RGB-COMP or HD15 is selected, “INVALID FUNCTION” appears to
indicate that operation is disabled.
∗5: When POP is not selected, “INVALID FUNCTION” appears to indicate that operation is
disabled.