Olympus UCR - Connecting Power and Gas Tubes

3.1 Installation workflow
25
UCR INSTRUCTION MANUAL
Ch.3
Chapter 3 Installation and Connection
Prepare the instrument and other compatible equipment (shown in the “ System chart” on page 67)
before each use.
Refer to the instruction manuals for each piece of equipment. Install and connect all equipment as
follows:
When the endoscopic CO
2
regulation unit is combined with the lens cleaning sheath, refer to the
instruction manual for the lens cleaning sheath before installing and connecting this instrument.
See the installation workflow in Figure 3.1 below. Follow each step of the workflow before using the
endoscopic CO
2
regulation unit.
3.1 Installation workflow
1
Install the instrument.
Section 3.2 on page 26
2
Connect the instruments to a CO
2
gas cylinder or the medical gas
pipeline adapter.
•CO
2
gas cylinderSection 3.3 on page 26
• Medical gas pipeline adapterSection 3.4 on page 29
3
Connect the instruments to the power source.
Section 3.5 on page 30
4
Connect the instruments to the gas tube.
*1
Section 3.6 on page 32
*1 When the lens cleaning sheath is used, do not connect the gas tube/water container to
the endoscope.
5
Connect the water container and endoscope.
*1
Section 3.7 on page 34