Omnicomm Optim 3.0 - Page 26

EN
25
Electronic version
Specication Value Notes
Analogue signal
Input voltage range From 0 to 30 V
Measurement resolution 12 bit
Basic percentage error
limits
± 1 %
Measurement rates 1 sec
Pulse and frequency signals
Pulse frequency From 10 Hz to 1 kHz
Pulse duration At least 1 msec
Signal amplitude At least 5 V
Potential signal
Voltage threshold to
recognize activation
From 1 to 30 V The threshold is to be
set in the software
Time when the voltage
is over the threshold
100 msec The status is
transmitted during the
data collection
Discrete outputs
Discrete outputs
number
2
Switching current, max 300 mA “Open collector” type
Global Positioning System GLONASS + GPS
Systems utilized GLONASS and GPS
jointly, 32 channels