Omnicomm Optim 3.0 - Installation Instructions

EN
28
Electronic version
Installation instructions
The list of necessary steps to install the device:
1. InstallingOmnicomm Optim Terminal’s component parts
2. Inserting SIM-cards and micro SD card
3. Connecting Omnicomm Optim Terminal
4. Conguring Omnicomm Optim Terminal with Omnicomm
Congurator Software
5. Sealing
Installing the device’s components
The Omnicomm Optim terminal shall be installed inside the VH cab
or in the boxes specially tted for electrical equipment in the VH
protected against penetration of atmospheric precipitations.
The Omnicomm Optim Terminal shall be installed on an even
surface.
It is recommended to install the GLONASS/GPS antenna on the
roof of VH. The GLONASS/GPS antenna shall be installed on a metal
surface. It is allowed to attach the antenna on a non-metal surface
using glue.
It is allowed to install the GLONASS/GPS antenna inside the VH in a
place where an adequate satellite signal coverage is available.
When installing inside the VH, allocation is to be installed on the
horizontal surface and have a necessary examination of quality of
reception of signal from GLONASS/GPS satellites.