142
CPM2C-S Series CPM2C-S
@@@
C (-DRT) Section 4-6
Dimensions (Same for All Units)
The CPM2C-S has rotary switches for DeviceNet settings and communica-
tions connector only if the CPM2C-S model number has a suffix of “DRT.” For
the dimensions of the CPM2C-S with wires connected or Expansion Units
mounted, refer to the CPM2C-S Series Operation Manual.
Timer/Counters 256 bits: TIM/CNT 000 to 255
1-ms timer (TMHH instruction), 10-ms timer (TIMH instruction), 100-ms timer
(TIM instruction), 1-s/10-s timer (TIML instruction), Decrementing counter
(CNT instruction), and reversible counter (CNTR instruction)
DM words Read/Write: 2,048 words (DM 0000 to 2047) (DM 2000 to 2021 are the error
log area.)
Read-only: 456 words (DM 6144 to 6599)
PLC Setup: 56 words (DM 6600 to 6655)
CompoBus/S Mas-
ter function
I/O points 256 points (128 inputs and 128 outputs) or 128 points (64 inputs and 64 out-
puts)
(Determined by the node number settings in the DM Area. The value is by
default set to 256.)
Number of points
per node number
8-point mode
Node number set-
ting
IN0 to IN15 and OUT0 to OUT15 or IN0 to IN7 and OUT0 to OUT7 (selected
with DM settings)
I/O words Input: 020 to 027 (CompoBus/S input bits)
Output: 030 to 037 (CompoBus/S output bits)
DeviceNet Slave function DeviceNet remote I/O link points: Up to 1,024 points (Up to 32 input words
and 32 output words)
Explicit message communications
Read/Write any desired area from the Master
Power failure backup function Flash memory: User program, DM (Read only), and PLC Setup
Memory backup: Holds DM (Read/Write), HR, AR, and CNT contents with
battery for 2 years at an ambient temperature of 25°C.
Programming Device CQM1H-PRO01-E, CQM1-PRO01-E, or C200H-PRO27-E Programming
Console
WS02-CXPC1-EV2 CX-Programmer
WS01-CPTB1-E SYSMAC-CPT
C500-ZL3AT1-E SYSMAC Support Software
Item Specification
(Unit: mm)
To Next Page
Loading...
