Omron C200HW-SRM21-V1 - 08-2007 - With 4 or 8 Transistor Outputs

277
Water-resistant Terminals Section 5-4
Note 1. Check that the junction of the contact block and cover is free of external
force imposed, or otherwise the IP67 enclosure rating will be lost.
2. Water-resistant Terminals used as Slaves are of IP67 construction. Do not
attempt to use the Water-resistant Terminals for applications where the
Water-resistant Terminals are always underwater.
3. The Unit is a plastic resin mold product. Do not tread on the Unit or put ob-
jects on the Unit.
OMRON’s 2-wired Proximity Sensors with relay connectors are classified into
M1GJ models, which have the IEC pin arrangement, and M1J models, which
have the OMRON pin arrangement. The following Water-resistant Terminals
are compatible with these different pin arrangements.
5-4-2 SRT2-OD@@CL (-1) Water-resistant Terminals with 4 or 8
Transistor Outputs
Specifications The following tables show the ratings and input specifications for the SRT2-
OD@@CL (-1).
Ratings
2-wired sensor (with relay connector) Compatible Water-resistant Terminals
IEC pin arrangement (M1GJ model) SRT2-ID04CL-1
SRT2-ID08CL-1
OMRON pin arrangement (M1J model) SRT2-ID04CL
SRT2-ID08CL
Item Specification
Models SRT2-OD04CL, SRT2-OD04CL-1, SRT2-OD08CL,
SRT2-OD08CL-1
I/O points SRT2-OD04CL: 4 output points (NPN)
SRT2-OD04CL-1: 4 output points (PNP)
SRT2-OD08CL: 8 output points (NPN)
SRT2-OD08CL-1: 8 output points (PNP)
Connection Communications
XS2C-D4S7: Connector Socket Assembly (female)
(Crimp terminals/Solder terminals)
Outputs
XS2G-D4@@: Connector Plug Assembly (male)
(Crimp terminals/Solder terminals)
XS2H-D421-@@@: Connector with cable (male plug on
one end)
XS2W-D42@-@@@:Connectors with cable (Socket/Plug
on both ends)
I/O power
XS2C-D4@@: Connector Socket Assembly (female)
(Crimp terminals/Solder terminals)
XS2F-D42@-@80-A: Connector with cable
(female socket on one end)
Power supply type Multiple power supplies
Communications power
supply voltage
14 to 26.4 V DC
(Power can be supplied from the communications cable)
I/O power supply voltage
20.4 to 26.4 V DC (24 V DC
+10%
/
–15%
)
I/O power supply current 2.4 A max.
Current consumption
(See note.)
Communications power: 50 mA max. at 24 V DC
Noise immunity 1.5 kVp-p with a pulse width of 0.1 to 1 µs and a rise time
of 1 ns (tested with impulse noise simulator)