236
Connector Terminals Section 5-2
5-2-4 SRT2-OD32ML (-1) Connector Terminals with 32 Transistor
Outputs
Specifications The following tables show the ratings and output specifications for the SRT2-
OD32ML (-1).
Ratings
Note This is the current consumption when all the maximum simultaneous input
points are ON, excluding the current consumption of external loads.
Item Specification
Models SRT2-OD32ML, SRT2-OD32ML-1
Output points/Connec-
tion type
SRT2-OD32ML: 32 points (NPN)/MIL connector output
SRT2-OD32ML-1: 32 points (PNP)/MIL connector output
Connection Communications power:
By communications connector (included as standard)
Output:
MIL connector or MIL-compatible Cables (both sold sepa-
rately) (see page 243)
I/O power:
MIL connector
Power supply type Multiple power supplies
Communications power
supply voltage
14 to 26.4 V DC
(Power can be supplied from the communications cable)
I/O power supply voltage
20.4 to 26.4 V DC (24 V DC
+10%
/
–15%
)
Current consumption
(See note.)
Communications power: 70 mA max. at 24 V DC
Noise immunity 1.5 kVp-p with a pulse width of 0.1 to 1 µs and a rise time
of 1 ns (tested with impulse noise simulator)
Vibration resistance
10 to 150 Hz, 0.7-mm double amplitude or 50 m/s
2
Shock resistance
150 m/s
2
Dielectric strength 500 V AC (between insulated circuits)
Ambient temperature Operating: –10 to 55°C (with no icing or condensation)
Storage: –25 to 65°C (with no icing or condensation)
Ambient humidity Operating: 25% to 85% (with no condensation)
Storage: 25% to 85% (with no condensation)
Operating environment No corrosive gases
Standard accessory 1 communications connector
Note Mounting Brackets B (SRT2-ATT02) is sold sepa-
rately
Mounting strength 50 N
Terminal strength Pulling: As stated below
Communications connector: 30 N
MIL connector: 30 N
Tightening torque Communications connector: 0.25 to 0.3 N • m
Node number settings The node number is set on a DIP switch. (Set the node
number before turning ON the Slave.)
Weight Approx. 90 g max.
To Next Page
Loading...
