235
Connector Terminals Section 5-2
Mounting Methods The following mounting methods can be used. These methods are the same
as those used for mounting Connector Terminals with 8 or 16 inputs.
• DIN track mounting (with no mounting brackets): Refer to page 208.
• Vertical panel mounting (with Mounting Bracket B only): Refer to
page 210.
• Horizontal panel mounting (with Mounting Bracket B only): Refer to
page 210.
Note The 32-point Connector Terminals cannot be directly panel-mounted with
screws. Use the SRT2-ATT02 Mounting Bracket B.
Mounting Bracket
Dimensions
SRT2-ATT02 Mounting Bracket B
Mounting Dimensions
Distance from Duct
Keep the Unit at least 20 mm away from the upper and lower ducts.
Mounting dimensions
Two, 3.2 dia. or M3 holes.
(Unit: mm)
Mounting
bracket B
Mounting
bracket B
(Unit: mm)
Direct DIN Track Mounting
Vertical Panel Mounting
DIN track
Horizontal Panel
Mounting
SRT2
IN
BS+
BSH
BSL
BS−
NC
NC
PWR
COMM1
ERR1
0
1
2
3
4
5
6
7
8
I
9
10
11
12
13
14
15
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
COMM2
ERR2
0.1
45 35
Duct
Duct
(Unit: mm)
To Next Page
Loading...
