59
Connector Installation (Special Flat Cable Only) Section 3-2
10. Check the assembled connector from the side and make sure that the
locks are completely engaged, as shown in the following diagram.
3-2-2 Extension Connector
Extension Connectors can be connected to any point of the communications
cable regardless of whether it is a main or branch line or whether the main line
needs to be distinguished from the branch lines.
Connector Components The Extension Connector has three components: Cover 1, Cover 2, and the
contact block. The following diagram shows Cover 1.
The following diagram shows Cover 2.
The following diagram shows the contact block.
Note Cover 1 and Cover 2 can be distinguished by the cover number.
Before Compression After Compression
Locks
Cover number
Hinge
Cover number
Hinge
Surface number
Cable Stop
Contacts
To Next Page
Loading...
