58
Connector Installation (Special Flat Cable Only) Section 3-2
7. Position Cover 2 onto Surface 2 of the contact block (the side without the
cable stop). Always align the cables so that the main cable’s colors match
the branch cable’s colors.
!Caution The Units could be damaged if the branch cable’s colors do not match the
main cable’s colors.
8. The branch cable must be inserted all the way to the contact block’s cable
stop.
9. Use a tool such as pliers to compress Cover 1 and Cover 2 together.
!Caution Always align the tool with the centers of the Covers to prevent any bending or
distortion when the connector is compressed. Uneven compression can pre-
vent proper communications.
Cover 1
Branch cable
Contact block
Main cable Cover 2
Main cable
tInser until the end of the branch cable is visible.
Make sure that the colors of the cables match.
Branch cable
To Next Page
Loading...
