195
Connector Terminals Section 5-2
Note This is the current consumption when all the maximum simultaneous input
points are ON, excluding the current consumption of external sensors.
Connection Input SRT2-VID08S (-1):
By XS8A-0441 Connector or XS8A-0442 Con-
nector (both sold separately)
SRT2-VID16ML (-1):
By XG4M-2030-T MIL Connector (sold sepa-
rately), or G79-050C, G79-025C, G79-150C and
G79-125C MIL-compatible Cables (all sold sep-
arately)
Communications
power
By communications connector (included as stan-
dard)
I/O power
Power supply type Multiple power supplies
Communications power supply
voltage
14 to 26.4 V DC
(Power can be supplied from the communications
cable)
I/O power supply voltage
20.4 to 26.4 V DC (24 V DC
+10%
/
–15%
)
I/O power supply current Cable connector: 2.4 A max.
MIL connector: 2.0 A max.
Current consumption
(See note.)
Communications power: 50 mA max. at 24 V DC
Noise immunity ±1.5 kVp-p with a pulse width of 0.1 to 1 µs and a
rise time of 1 ns (tested with impulse noise simula-
tor)
Vibration resistance
10 to 150 Hz, 1.0-mm double amplitude or 70 m/s
2
Shock resistance
200 m/s
2
Dielectric strength 500 V AC (between insulated circuits)
Ambient temperature Operating: –10 to 55°C
(with no icing or condensation)
Storage: –25 to 65°C
(with no icing or condensation)
Ambient humidity Operating: 25% to 85% (with no condensation)
Storage: 25% to 85% (with no condensation)
Operating environment No corrosive gases
Standard accessory 1 communications connector
Note: Mounting Brackets A (SRT2-ATT01) and B
(SRT2-ATT02) are sold separately.
Mounting strength Pulling: 100 N in each direction.
(When mounted with Mounting Bracket B: 40 N)
Terminal strength Pulling: As stated below.
Communications connector: 100 N
Cable connector: 40 N
MIL connector: 100 N
Tightening: 0.25 N • m (for communications con-
nector)
Node number settings The node number is set on a DIP switch. (Set the
node number before turning ON the Slave.)
Weight Approx. 75 g
Item Specification
To Next Page
Loading...
