222
Connector Terminals Section 5-2
2. When inductive loads such as solenoids and valves are used, either use
loads with built-in diodes that absorb the back-electromotive force or con-
nect a diode externally.
Note 1. The V terminals are all connected internally, as are the G terminals. When
providing I/O power from a communications connector, power can be pro-
vided to output devices from the V and G terminals of the MIL Connector.
2. When inductive loads such as solenoids and valves are used, either use
loads with built-in diodes that absorb the back-electromotive force or con-
nect a diode externally.
Compatible External Output Devices and Cables
Models with Sensor Connectors (SRT2-VOD08S-1)
The XS8A-0441 and XS8A-0442 Connectors (sold separately) are used to
connect to external output devices. Use the following flowchart to check the
compatibility of external output devices and cables. Refer to 3-4-3 Cable Con-
nector Wiring and Assembly for details on the assembly, wiring, and installa-
tion of cable connectors.
SRT2-VOD16ML
CompoBus/S
communications
CompoBus/S
communications
power supply
I/O power
supply
Output
device
Valve, etc.
Solenoid, etc.
SRT2-VOD16ML-1
▲Mark
CompoBus/S
communications
CompoBus/S
communications
power supply
I/O power
supply
Valve, etc.
Solenoid, etc.
▲Mark
Output
device
Output
device
Output
device
Locking Lever
To Next Page
Loading...
