298
Sensor Terminals Section 5-5
Node Number Settings
Set the node number with pins 1 through 4, as shown in the following table.
Note The actual node number setting range depends on the type of PLC in which
the Master is mounted as well as the Master’s settings. Refer to 2-1 Commu-
nications Specifications for details.
Compatible External
Devices and Cables
Remote Terminals with Connector Output Transistors use the XS8A-0441 and
XS8A-0442 Connectors (sold separately) to connect to external devices. Use
the following flowchart to check the compatibility of external devices and
cables. Refer to 3-4-3 Cable Connector Wiring and Assembly for details on
the assembly, wiring, and installation of cable connectors.
Node number Pin 4
(8)
Pin 3
(4)
Pin 2
(2)
Pin 1
(1)
0 OFF OFF OFF OFF
1 OFF OFF OFF ON
2 OFF OFF ON OFF
3OFFOFFONON
4 OFF ON OFF OFF
5 OFF ON OFF ON
6 OFF ON ON OFF
7 OFF ON ON ON
8 ON OFF OFF OFF
9ONOFFOFFON
10 ON OFF ON OFF
11 ON OFF ON ON
12 ON ON OFF OFF
13 ON ON OFF ON
14 ON ON ON OFF
15 ON ON ON ON
Locking lever
To Next Page
Loading...
