69
Master/Slave Connecting Cables Section 3-4
Note In accordance with the changes in the standards for photoelectric sensors
and proximity sensors, wire colors have been changed. Colors in parentheses
are the old wire colors.
When connecting an output device, match the terminal numbers marked on
the connector cover with the signal wires of the output device as shown in the
following table.
Insert the wire all the way into the cover’s hole until it touches.
Connector Assembly
Use the following procedure to assemble the cable connector.
1,2,3... 1. Check the wire colors and make sure that the sensor’s wires are aligned
with the correct terminal numbers. (The cover is semi-transparent, so the
wire colors will be visible through the cover.)
2. Fit the cover (with wires inserted) into the connector plug, as shown in the
following diagram.
3. Use a tool such as pliers to press the cover all the way into the connector
plug. Always align the tool with the center of the cover so it does not tilt,
SRT2-VID08S-1 3-wire sensor
(without self-diagnostic out-
put function)
Black (white)
(Connect to 1 or
2)
Brown
(red)
Blue
(black)
2-wire sensor
(without self-diagnostic out-
put function)
Blue (black)
(Connect to 1 or
2)
Brown
(white)
---
Sensor terminal Sensor type Terminal number
1234
SRT@-ID08S 3-wire sensor
(without self-diagnostic out-
put function)
Black
(white)
--- Brown
(red)
Blue
(black)
2-wire sensor
(without self-diagnostic out-
put function)
Brown
(white)
--- --- Blue
(black)
SRT@-ND08S Sensor with teaching func-
tion or external diagnostic
function
Black
(white)
Pink
(gray)
Brown
(red)
Blue
(black)
Sensor with bank switching
function
Black Purple Brown Blue
Sensor terminal Sensor type Terminal number
1234
Sensor terminal Terminal number
1234
SRT2-VOD08S Yes (Connect to 1 or 2) Yes ---
SRT2-VOID08S-1 Yes (Connect to 1 or 2) --- Yes
SRT@-OD08S Yes --- Yes (Connect to 3 or 4)
To Next Page
Loading...
