Introduction
6
CJ-series PROFIBUS Slave Unit Operation Manual for NJ-series CPU Unit (W510)
Section 8
Other Units
This section provides the basic specifications for the other Units used in Slice I/O ter-
minals.
Section 9
Troubleshooting
This section describes error processing and troubleshooting procedures needed to
keep the Slice I/O Units operating properly.
Appendices
The appendices describe the following:
Explicit Messages
Standard Models
Power Consumption and Weight Tables
I/O Current Consumption Table
Precautions When Connecting Two-wire DC Sensors
CS/CJ-Series PROFIBUS Master Units Operation Manual (Cat. No.
W409)
Section Description
Section 1
Features and Specifications
This section provides an introductory overview of PROFIBUS, its functions and how
to setup and configure a network. It also addresses the PROFIBUS Master Units and
the configurator, their features and specifications.
Section 2
Installation and Wiring
This section shows the PROFIBUS device and identifies its controls and indicators. It
contains the procedures for installing the CS1/CJ1W-PRM21 PROFIBUS Master Unit
and configuring the PROFIBUS network.
Section 3
Configuration Software
This section contains the procedures for installing the configuration software. It also
presents an overview of the Configuration software and discusses the main aspects
of defining a PROFIBUS configuration.
Section 4
Allocated CIO and DM Words
This section describes the words allocated to the CS1/CJ1W-PRM21 PROFIBUS
Master Unit in the CIO and DM Areas.
Section 5
FINS Commands and Responses
This section describes the FINS message service communications commands con-
cept as well as the commands supported by the CS1/CJ1W-PRM21 PROFIBUS
Master Units.
Section 6
Operation
This section describes how to operate the CS1/CJ1W-PRM21 PROFIBUS Master
Unit in a Network. It will discuss setting up a network, configuring all the connected
devices and starting the network. Furthermore, it provides information the I/O data
exchange performance and it also provides information on how to monitor a network
using the Unit and CX-ConfiguratorFDT.
Section 7
Troubleshooting and Maintenance
This section describes the troubleshooting procedures and maintenance operations
for the CS1/CJ1W-PRM21, needed to keep the PROFIBUS network optimally work-
ing.
Appendix
The appendices describe the following:
Bus Parameters
Slave Diagnostics
I/O Data Conversions
Configuration Error and Warning Messages
Memory Card Backup Functions
Application Notes
C200HW-PRM21 Notes
Section Description
To Next Page
Loading...
