Omron CJ2H-CPU6*-EIP Series - Device Configuration

5
．
Applicable Devices and Device Configuration
6
5.2. Device Configuration
The hardware components to reproduce the connection procedures in this document are as
follows:
Manufacturer
Name
Model
Version
OMRON
CJ2 CPU Unit
(Built-in EtherNet/IP port)
CJ2M-CPU32
Ver.2.0
(Ver.2.12)
OMRON
Power Supply Unit
CJ1W-PA202
OMRON
Switching hub
W4S1-05C
Ver.1.00
-
24 VDC power supply
(for Switching hub)
-
OMRON
CX-One
CXONE-AL[][]C-V4
/AL[][]D-V4
Ver.4.[][]
OMRON
CX-Programmer
(Included in CX-One)
Ver.9.61
OMRON
Network Configurator
(Included in CX-One)
Ver.3.59c
-
Personal computer
(OS: Windows 7)
-
-
USB cable
(USB 2.0 type B connector)
-
-
LAN cable (STP (shielded,
twisted-pair) cable of Ethernet
category 5 or higher)
-
OMRON Sensor Controller ZW-7000 Ver.2.020
OMRON Sensor Head ZW-S7030
OMRON Calibration ROM (Supplied with Sensor Head)
OMRON
24 VDC power supply (for Sensor
Controller) (24 VDC, 2.5A, 60W）
S8VS-06024
Precautions for Correct Use
Update CX-Programmer and Network Configurator to the version specified in this Clause 5.2.
or to a higher version. If you use a version higher than the one specified, the procedures and
related screenshots described in Section 7. and subsequent sections may not be applicable.
In that case, use the equivalent procedures described in this document by referring the
CX-Programmer OPERATION MANUAL (Cat. No. W446) and Network Configurator Online
Help.
ZW-7000
24 VDC power supply
(for Sensor Controller)
Calibration ROM
CJ2M-CPU32
(Built-in EtherNet/IP port)
USB cable
Personal computer
(CX-One installed,
OS: Windows 7)
24 VDC power supply
LAN cable
W4S1-05C