68
2-5. Stress Mode
5. Select the measurement sites and press the [OK]
button.
6. Press the [OK] button.
7. Press the [OK] button.
8. Set the exercise stress conditions.
• DISTANCE: 0 to 1000 m
(Walking distance)
• DEGREE: 0 to 30%
(Angle of treadmill)
• SPEED: 0 to 100 m/min
(Treadmill speed)
• INTERVALS: 2, 3, 4, 5 minutes
(Time until measurement begins after exercise)
9. Start applying the exercise stress to the patient.
Apply the exercise stress to the patient based on the exercise stress conditions set in step 8.
10.Attach cuffs and sensors to the patient.
Immediately after applying the exercise stress, attach
the ankle cuff, ECG clips, and PCG sensor. Connect the
arm cuff to the cuff hose.
BP-203RPE3(A).fm 68 ページ ９年月６日 土曜日 午後５時４分
To Next Page
Loading...
