5 Advanced Operations
5 - 66
E5@C-T Digital Temperature Controllers User’s Manual (H185)
In the following cases, timing of program progression is continued.
• When you change to Manual Mode during program operation
• When an input error occurs during program operation
• When a potentiometer input error occurs during program operation
If you move to the Initial Setting Level, program operation will stop, the control outputs will turn OFF, and
the following outputs will turn OFF: time signal outputs, program end output, run output, and stage out-
put.
5-15-16 Operations Related to Other Functions
Changing to Manual Mode during Operation and Operation for
Errors
Operation When Moving to the Initial Setting Level
To Next Page
Loading...
