Omron FQ2-S Series User Manual

Command Control
FQ2-S/CH User’s Manual
for Communications Settings
245
5
Appendices
Load All Setting Data
This command loads all setting data (all scene data, system data, calibration group data) for the Sensor saved
as a backup file from the SD card inserted in the Touch Finder.
The source for backup files is the following fixed directory on the SD card.
\Sensor name\BKD
The file name is not case sensitive. The file name extension can be omitted.
After loading the all data with this command, be sure to restart the Vision Sensor to enable the data that was loaded.
Command (PLC to Vision Sensor)
*1 Loads the files named SensorAll_***.bkd saved on the SD card. (***: Specified file number)
Response (Vision Sensor to PLC)
First word of com-
mand area
Bits Contents
12 to 15 8 to 11 4 to 7 0 to 3
+2 0101 0000 0000 0000 Command code
+3 0000 0000 0110 0000
+4 0000 0000 0000 0000 • EtherNet/IP,
PROFINET
File number to load
(0 to 999)*1
• PLC link
File name to load
64 characters max.
The file name exten-
sion (.bkd) can be
omitted.
+5 0000 0000 0000 0000
+6 0000 0000 0000 0000
---
: ::::
+37 0000 0000 0000 0000
First word of
response area
Bits Contents
12 to 15 8 to 11 4 to 7 0 to 3
+2 0101 0000 0000 0000 Command code
Response target command codes
+3 0000 0000 0110 0000
+4 0000 0000 0000 0000 Response code
Command execution result
0: OK, FFFFFFFF: NG
+5 0000 0000 0000 0000
Important
FQ2-S_CH_comm.book 245 ページ ２０１４年６月２６日 木曜日 午前１１時４７分

Omron FQ2-S Series Specifications

General

Brand	Omron
Model	FQ2-S Series
Category	Security Camera
Language	English