Omron FQ2-S Series - Page 266

Command Control
264
FQ2-S/CH User’s Manual
for Communications Settings
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
CLRTOTAL or CTD
Clear Statistical Data
This command clears the statistical data (such as the number of measurements, the number of NG overall
judgments, the NG rate, and other information since the power supply was turned ON) produced by the logging
function held by the Sensor.
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
DATASAVE
Save Settings
This command saves the current system data and all scene data in the Sensor.
<Command Format>
CR OK
Delimiter
CR ER
Delimiter
RTCL CR OTAL
Delimiter
CR CTD
Delimiter
or
CR OK
Delimiter
CR ER
Delimiter
DA CR TA ASEV
Command
Delimiter
FQ2-S_CH_comm.book 264 ページ ２０１４年６月２６日 木曜日 午前１１時４７分