Command Control
266
FQ2-S/CH User’s Manual
for Communications Settings
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
<Parameter Descriptions>
MEASURE or M
Start Continuous Measurements
This command starts continuous measurements.
If data output is not set, only continuous measurement is performed.
If data output is set, continuous measurement is performed and the results corresponding to the number of
measurements made are returned as response data.
<Command Format>
Inspection item number Specifies the item number of the inspection item that teaching will be performed on. (0 to
31)
Only "0" can be specified with the FQ2-S1 series.
IT
CR
EMT EA CH
or
Inspection item number
(2 digits max.)
Delimiter Delimiter
Space
(0x20)
Space
(0x20)
CR
IT
Inspection item number
(2 digits max.)
A S M E
CR
U R E / C
Delimiter
CR
M / C
or
Space (0x20)
Delimiter
Space (0x20)
FQ2-S_CH_comm.book 266 ページ ２０１４年６月２６日 木曜日 午前１１時４７分
To Next Page
Loading...
