Omron FQ2-S Series - Page 269

Command Control
FQ2-S/CH User’s Manual
for Communications Settings
267
5
Appendices
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
<Parameter Descriptions>
End Continuous Measurements
The command ends continuous measurements.
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
Measurement result The measurement results corresponding to the number of measurements made are out-
put when data output is set.
The measurement result is not output when data output is not set.
Setting the Data to Output Automatically after Measurements: p. 169
CR
CR
CR
OK
CR
Delimiter
Data returned for the number of
continuous measurements made.
Measure-
ment result
Measure-
ment result
Measure-
ment result
CR ER
Delimiter
A S M E CR U R E / E CR M / E
or
DelimiterSpace (0x20)DelimiterSpace (0x20)
CR OK
Delimiter
CR
Measurement
result
CR OK
CR
Delimiter
Measurement
result
Data returned
for the number
of continuous
measurements
made.
FQ2-S_CH_comm.book 267 ページ ２０１４年６月２６日 木曜日 午前１１時４７分