Command Control
280
FQ2-S/CH User’s Manual
for Communications Settings
DIOFFSET or DIO
Acquire Terminal Offset Data
This command acquires the terminal offset data that is added to the IN0 to IN4 command parameters when
executing parallel commands.
If no value has been set with the Set Terminal Offset command, "0" is returned as the terminal offset value and
"OK" (ended normally) is returned for the end code.
Set Terminal Offset Data: p.306
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
<Parameter Descriptions>
Acquired value Returns the value added to the IN0 to IN4 command parameters when executing parallel
commands.
DI FSET
CR
O
DIO
F
Command
Delimiter
Delimiter
Command
or
CR
CR
Acquired
value
Delimiter
CR
OK
FQ2-S_CH_comm.book 280 ページ ２０１４年６月２６日 木曜日 午前１１時４７分
To Next Page
Loading...
