Omron FQ2-S Series - Page 285

Command Control
FQ2-S/CH User’s Manual
for Communications Settings
283
5
Appendices
GETITEMFIGPARAM or GIFP
Acquire Measurement Region/Model Region Information Set for an Inspection Item
This command acquires the parameters for the measurement region or model registration region set for an
inspection item.
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
To check the figure number to be used when specifying a figure to change the settings of with the Set Inspection
Item Figure command, do so using this command.
Note
GE MF I GPARAM
CR
TI ET
Region
number
(
1 digit )
Figure number
(1 digit)
Command
Space
(0x20)
Delimiter Space
(0x20)
Space
(0x20)
Inspection item
number
(2 digits max.)
Space
(0x20)
Space
(0x20)
Inspection item
number
(2 digits max.)
Command
or
IGPF
Region
number
(1 digit)
Figure
number
(1 digit)
CR
Delimiter
Space
(0x20)
CR OK
Delimiter
Comma (fixed separator character)
Comma (fixed separator character)
Parameter 1 Parameter 2 ,
CR
... Parameter 21,
CR ER
Delimiter
FQ2-S_CH_comm.book 283 ページ ２０１４年６月２６日 木曜日 午前１１時４７分