Omron FQ2-S Series - Page 333

Command Control
FQ2-S/CH User’s Manual
for Communications Settings
331
5
Appendices
SYSLOAD
This command loads system data that is stored on the SD card inserted in the Touch Finder.
The source for system data is the following fixed directory on the SD card.
\Sensor name\SYD
<Command format>
<Response format>
When Processing Is Performed Normally
When Processing Is Not Performed Normally
<Parameter Descriptions>
Do not turn off power to the Vision Sensor until there is a response.
File name of system data Specifies the system data file name to be loaded.
The extension (.syd) can be omitted.
SYSLOAD
C
R
File name of system dataSpace (0x20)
Important
FQ2-S_CH_comm.book 331 ページ ２０１４年６月２６日 木曜日 午前１１時４７分