Command Control
340
FQ2-S/CH User’s Manual
for Communications Settings
IMAGESAVE
Saves image data saved in the Sensor's memory by the logging function to the SD card inserted in the Touch
Finder as ifz data.
The destination for image data is the following fixed directory on the SD card.
\Sensor name\LOGIMAGE\Number
*
*Number is a five digit number starting from 00000. The images are saved in increments of 100 images for each number, and when there
are over 100 images, the directory with the next number is created.
<Command format>
or
<Response format>
When Processing Is Performed Normally
When Processing Is Not Performed Normally
<Parameter Descriptions>
• If the specified file name already exists, this existing file will be overwritten.
• Do not turn off power to the Vision Sensor until there is a response.
Image data number Specifies the number of the image data to be saved.
The maximum number of logged images is 20 (image data number: 0 to 19).
The image data number of the latest image is 0.
Image data file name Specifies the image data file name when saving. (64 characters max.)
The file name extension (.ifz) can be omitted.
IM G SAAVEE
Image data number (2 digits max.)
C
R
Image data file name when saving
IS
Image data number (2 digits max.)
C
R
Image data file name when saving
FQ2-S_CH_comm.book 340 ページ ２０１４年６月２６日 木曜日 午前１１時４７分
To Next Page
Loading...
