136 LDî ±Platform Peripherals Guide 13732-000 Rev J
9.3 î ±Sensor Installation on the LD-60, LD-90, and LD-xxxCT
Figure 9-6 Mounted Sensors
b.
Cable-tie the wires from the front sensor to the rear to the anchors.
4.
Proceed to the next section, Single and Dual-Sensor Installation, Part 2.
Single and Dual-Sensor Installation, Part 2
1.
Route the sensor wires, both data and power, up through the platform chassis, just
behind the right drive wheel, and through the cutout shown in the following figure.
Figure 9-7 Cutout in Payload Bay for Cables
Cable-tie the cables to the anchors previously installed behind the right wheel. See Fig-
ure 9-2
To Next Page
Loading...
