105
8 Connect the cable to the NQ-Series and PLC. Refer to A-4-6 NQ to Mitsubishi FX PLC (8 Pin Connector) or
A-4-7 NQ to Mitsubishi FRS Inverter. Connect the PLC end port to the Mitsubishi FX PLC. Connect the NQ-
Series’ male port of the cable to the defined COM1 port of the NQ-Series.
9Enter 11 in the NQ-Series’ screen. If the connection has been correctly established the same value is shown
in Mitsubishi Series PLC software.
Note
The following messages are displayed on the NQ-Series’ screen if problems occur:
• !!! no connection
• ??? connection established, address unknown
To Next Page
Loading...
