NQ-Series diagnostics Section 7-4
73
Table 7.3: System set-up settings
Pressing the buttons on one of the 2 set-up screens will take you to the
specific set-up procedures for the specific settings.
Setting Description
TouchScreen Calibrate To calibrate the touch screen. Refer also to 7-2 Touch
screen calibration.
Brightness Control To set the brightness of the screen.
Contrast Control To set the constrast of the screen (NQ5)
RTC Settings To set the RTC.
Com Port Settings To set the com port.
ScreenSaver Time To set the screensaver time.
Application Erase To erase the application.
Note that if you perform this
action you can not continue with NQ-Series diagnos-
tics.
Firmware Erase To erase the firmware. Note that if you perform this
action you can not continue with NQ-Series diagnos-
tics.
Beeper Setting To set the beeper.
Battery Status To view the battery status.
Clear retentive registers To clear all retentive registers.
System Information To view the system information.
To Next Page
Loading...
Need help?
General