Section 3
Installing the PT and Connecting
Peripheral Devices
This section describes the methods used to install the PT and connect peripheral devices.
For details on methods for connecting the host, refer to Section 4 Connecting the Host to the Se-
rial Port or Section 5 Connecting to Host via Ethernet or Controller Link.
3-1Installing the PT................................................................................................................... 3-3
3-1-1 Installation Environment........................................................................................... 3-3
3-1-2 Installing Expansion Memory Boards and RS-232C/RS-422A Converters.............. 3-4
3-1-3 Mounting the PT to the Control Panel...................................................................... 3-4
3-1-4 Connecting the Power Supply................................................................................... 3-5
3-1-5 Wiring the Ground Wire........................................................................................... 3-6
3-2Starting the PT ..................................................................................................................... 3-7
3-2-1 Operation at Startup.................................................................................................. 3-7
3-2-2 Starting the PT for the First Time............................................................................. 3-9
3-3Connecting the NS-Designer.............................................................................................. 3-11
3-4Connecting to Bar Code Readers....................................................................................... 3-12
3-4-1 Connection Methods............................................................................................... 3-12
3-4-2 Setting Bar Code Readers....................................................................................... 3-13
3-4-3 Data Format............................................................................................................ 3-14
3-4-4 Bar Code Input ....................................................................................................... 3-14
3-5Using Expansion Memory Boards ..................................................................................... 3-15
3-5-1 Installation Procedure............................................................................................. 3-16
3-5-2 Using the Board...................................................................................................... 3-17
3-6Using Memory Cards......................................................................................................... 3-18
3-6-1 Installation .............................................................................................................. 3-19
3-6-2 Replacing System Programs ................................................................................... 3-20
3-6-3 Transferring Data with Memory Cards................................................................... 3-20
3-7Installing the Video Input Unit .......................................................................................... 3-27
3-7-1 Video Input Unit Components................................................................................ 3-27
3-7-2 Nomenclature and Functions .................................................................................. 3-28
To Next Page
Loading...
Need help?
General
