Omron NX-SL series User Manual

2 Standard Functions
2 - 48
NX-series Safety Control Unit Instructions Reference Manual (Z931)
TIME_TO_DINT
This function converts a TIME variable to a DINT variable.
If you omit an input or output parameter, a building error will occur.
This function converts TIME data In to DINT data Out.
Example When Value of In Is 1 day 1 h 1 min 30 s 90 ms (T#1d1h1m30s090ms)
• The value of Out will be DINT#90090090.
To convert DINT data to TIME data, refer to DINT_TO_TIME.
• The input condition depends on whether the output is safety data or standard data. If the condition is
not met, a building error will occur.
• If you set a safety data type variable for the output terminal, set a safety data type variable for the
input terminal as well.
• If you set a standard data type variable for the output terminal, you can set either a safety data type
variable or a standard data type variable for the input terminal.
Instruction Name FB/FUN Graphic expression
TIME_TO_DINT Convert TIME to
DINT
FUN
Variables
Name I/O Description Valid range Default
In Data to con-
vert
Input Duration T#0ms to
T#49d17h2m47s295ms
T#0ms
Out Conversion
result
Output Integer DINT#0 to 2147483647 DINT#0
Boolean Bit strings Integers Durations
BOOL SAFEBOOL BYTE SAFEBYTE WORD SAFEWORD DWORD SAFEDWORD INT SAFEINT DINT SAFEDINT TIME SAFETIME
In OK OK
Out OK OK
Function
Additional Information
Precautions for Correct Use
TIME_TO_DINT

Omron NX-SL series Specifications

General

Brand	Omron
Model	NX-SL series
Category	Control Unit
Language	English