3-10
3-4 Part Names and Descriptions of the Digital Operator
3
Operation
Operation Example for Basic Display (factory default: "b037 = 04")
• Displays the limited basic parameters.
• Other parameters than those mentioned above are not displayed. To display all parameters, select
"Complete display 'b037 = 00'".
<Parameters to be Displayed and Arrangement>
* If the intended parameter is not displayed, check the setting of display selection "b037".
To display all parameters, set "00" to "b037".
Monitor mode : All
Basic function mode : 4 parameters
Extended function mode : 24 parameters
NO. Display code Item
1 d001 to d104 Monitor display
2 F001 Output frequency setting/monitor
3 F002 Acceleration time 1
4 F003 Deceleration time 1
5 F004 Operator rotation direction selection
6 A001 Frequency reference selection
7 A002 RUN command selection
8 A003 Base frequency
9 A004 Maximum frequency
10 A005 O/OI selection
11 A020 Multi-step speed reference 0
12 A021 Multi-step speed reference 1
13 A022 Multi-step speed reference 2
14 A023 Multi-step speed reference 3
15 A044 V/f characteristics selection
16 A045 Output voltage gain
17 A085 RUN mode selection
18 b001 Retry selection
19 b002 Allowable momentary power interruption time
20 b008 Trip retry selection
21 b011 Trip retry wait time
22 b037 Display selection
*
23 b083 Carrier frequency
24 b084 Initialization selection
25 b130 Overvoltage protection function during deceleration
26 b131 Overvoltage protection level during deceleration
27 C021 Multi-function output terminal 11 selection
28 C022 Multi-function output terminal 12 selection
29 C036 Relay output (AL2, AL1) contact selection
To Next Page
Loading...
