89
Setting and Saving Parameters Section 6-3
out of range is set, it will be checked and rejected when the settings are
downloaded.
(5) If the parameters in the S8M-CP04-RS are initialized by selecting Com-
munication - Initialize Parameters, the abnormal current tripping value
and overcurrent alarm value will be set to 3.8 A. The same values on the
computer are always set to 4.0 A when the parameters are initialized by
selecting Edit - Initialize with the Support Tool, because the Support Tool
does not distinguish between S8M models.
Saving the
Parameters
This operation saves the edited parameters in a file.
Select File - Save New File to save the file.
Note When a file is saved, a note such as the output's name can be entered in the
Comment Field. The comment is not transferred to the S8M, so it is just used
as a comment in the Support Tool itself.
Downloading the
Parameters
This operation writes the edited parameters from the Support Tool to the S8M.
• Connect to the computer with the RS-232C cable.
1,2,3... 1. Select Communications - Download.
Note (1) Setting parameters in the Parameter Setting Window does not directly set
or change the S8M parameters online, it sets the parameters offline in the
▲
▲
The file name is displayed as a title.
If a file comment was entered, the comment
will be displayed when the file is read.
RS-232C cable
Write parameters.
Support Tool
To Next Page
Loading...