Omron S8M - Page 152

134
List of Operations Appendix B
Setting Mode
Select Run Mode
Setting Mode
u p s
d w s
t r g
u n o
b p s
l e n
b i t
p t y
s w t
/
+
Current tripping type
Settings apply to branch
outputs 1 to 4.
c - V
a - V
c - t
a - t
V - u
V - o
t i m
t m p
c l r
r u n
s e t
t s t
p r t
i n i
Mode Selection Menu
Mode Selection Menu
/
Setting the Parameters
+
First Power ON after Purchase
Current tripping value
Overcurrent alarm value
Overcurrent alarm
type
Undervoltage alarm value
Overvoltage alarm value
Run time value
Over-temperature output value
Clear run time (See note.)
Startup sequence
Applies to
branch
outputs 1 to 4.
Applies to
branch
outputs 1 to 4.
Applies to
branch
outputs 1 to 4.
Shutdown sequence
External tripping input
Unit number
Baud rate
Data length
Stop bits
Parity
Send wait time
(Press for 3 s.)
Power ON after being in Run Mode
Run Mode
Select Setting Mode
Select Test Mode
(See note 1.)
Restart after Power
OFF in Test Mode
Test Mode
Protection level
Initialize parameters.
(See note 2.)
Initialize
parameters
(See note 2.)
Set
protection
level.
Note 1: The "TST" display does not appear in protection level 2.
Note 2: The "INI" display does not appear in protection level 1 or 2.
Display set value.
Change set value.
Save set value.
The display flashes, the setting is saved, and the
original display returns.
Key
Key (Transition when S8M is in protection level 0)
Key (Press for 3 s.)
No keys pressed for 5 s.
Key
/
When the S8M is in protection level 0, all of the settable
items will be displayed in Setting Mode.
When the S8M is in protection level 1 or 2, only the items in
the will be displayed.
The "CLR" display does not appear in protection level 2.