135
List of Operations Appendix B
Test Mode
Restart after Power OFF in Test Mode
Connect/disconnect branch output 1.
Connect all branch outputs.
(Press for 3 s.)
Connect/disconnect branch output 2.
Connect/disconnect branch output 3.
Connect/disconnect branch output 4.
Note 1: The "TST" display does not appear
in protection level 2.
Note 2: The "INI" display does not appear in
protection level 1 or 2.
Press the Key to when "ON" is flashing to connect all outputs
and check the operation of the startup sequence.
The ON/OFF display and the branch output number will flash in Test
Mode.
When "ON" is flashing, the S8M is waiting to connect the output. Press
the Key to connect the output.
When "OFF" is flashing, the S8M is waiting to disconnect the output.
Press the Key to disconnect the output.
o
n
r
u
n
s
e
t
t
s
t
p
r
t
i
n
i
1 2 3 4
o
f
f
1 2 3 4
o
n
1 2 3 4
o
f
f
1 2 3 4
o
n
1 2 3 4
o
f
f
1 2 3 4
o
n
1 2 3 4
o
f
f
1 2 3 4
+
o
n
1 2 3 4
o
f
f
1 2 3 4
/
o
n
1 2 3 4
o
f
f
1 2 3 4
Mode Selection Menu
Select Run Mode.
Select Setting
Mode.
Select Test Mode.
(See note 1.)
Protection level
Initialize parameters.
(See note 2.)
Test Mode
Disconnect all branch outputs.
/
/
/
/
/
/
Press the Key to when "OFF" is flashing to disconnect all
outputs and check the operation of the shutdown sequence.
Connecting/Disconnecting All Branch Outputs
To Next Page
Loading...