Omron S8M - Page 55

37
Installation Section 3-2
DIN Rail Installation Always install the S8M on DIN Rail.
■ Recommended DIN Rail
PFP-50N (50 cm), PFP-100N (100 cm), or PFP-100N2 (100 cm)
Mount the DIN Rail with M4 screws in at least three places, with a maximum
separation of 210 mm (6 holes) between screws. The tightening torque is 1.2
N·m (10.8 in·lb).
Attachment to the DIN
Rail
The S8M attaches to the DIN Rail with one snap. Hang the S8M on the top of
the DIN Rail with the installation notch on the back of the S8M, pivot the S8M
downward, and press until the S8M locks securely on the Rail.
1,2,3... 1. Lower the S8M so that the installation notch hooks onto the top of the DIN
Rail.
15
10
4.5
25
25
25
10
25
15
1,000
1,000 (500)
(See note.)
PFP-100N2
PFP-100N/50N
15
10
4.5
25 25
25
10
25 15 (5)
(See note.)
1
16
1.51
29.2
24
27
28.25 × 4.5 oblong holes
30±0.3
7.3±0.15
35±0.3 27±0.15
Note: PFP-50N dimensions are given in parentheses.