52
Switching the Operating Mode Section 4-3
Switching between Displays in the Mode Selection Menu
r u
n
s e
t
t s
t
p r
t
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
When the S8M is switched to the Mode Selection Menu from
Run Mode, the display will show “RUN.” At this point, the S8M
will automatically enter Run Mode if the Mode Key ( ) is
pressed or the Up Key ( ) or Down Key ( ) isn't pressed
within 5 s.
If the Down Key ( ) is pressed, SET will be displayed. If the
Mode Key ( ) is pressed at this point, the S8M will enter Set-
ting Mode.
Refer to 4-4 Changing the Protection Level to 4-6 Individual
Branch Output Settings for details on setting parameters.
If the Down Key ( ) is pressed, TST will be displayed. If the
Mode Key ( ) is pressed at this point, the S8M will enter Test
Mode.
See SECTION 5 Trial Operation to Actual Operation for details
on Test Mode.
If the Down Key ( ) is pressed, PRT (protect) will be dis-
played. If the Mode Key ( ) is pressed at this point, the S8M
will switch to the protection level display.
(If the Key is pressed, INI will be displayed.)
i n
i
23
4
°C
kh
V
A
s
1
If the protection level is set to level 0, INI will be displayed
when the Down Key ( ) is pressed. If the Mode Key ( ) is
pressed at this point, the S8M will switch to the parameter ini-
tialization display.
Note The default protection level is level 1 and the INI option will not
be displayed in protection level 1.
(If the Down Key ( ) is pressed, the S8M will return to the
RUN display.)
To Next Page
Loading...