53
Switching the Operating Mode Section 4-3
Note The procedure for initializing parameters is as follows:
After the parameters have been initialized, the default settings will be in effect
and the initial power-ON status will be used.
• The operating mode will be Setting Mode.
• All branch outputs will be disconnected.
• Protection level 1 will be used.
i n i
n o
y e s
i n i
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
c - ?
23
4
°C
kh
V
A
s
1
Press the Mode Key ( ) from the ini-
tialize display (INI). The S8M will
switch to the parameter initialization
display.
NO will be displayed. Initialization
cannot be performed from this display.
(The S8M will automatically return to
Run Mode if no key is pressed within
5 s.)
Press the Up Key ( ). The display
will change to YES. The parameters
will be initialized if the Mode Key ( )
is pressed from this display.
(The S8M will automatically return to
Run Mode if no key is pressed within
5 s.)
Press the Mode Key ( ) to start ini-
tializing parameters. INI will flash on
the display while parameters are
being initialized. When the display
stops flashing, all parameters will
have been initialized.
The operating mode will change to
Setting Mode and the abnormal volt-
age tripping value will be displayed
for branch output 1.
To Next Page
Loading...