72
Special Settings and Communications Settings Section 4-8
n o
y e s
(Return to CLR display.)
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
Switch to the cur-
rent tripping
value setting for
branch output 1.
Press the Key to display the run time clear
setting. The setting can be changed by pressing
t
he or Key.
No: Do not clear the run time.
Yes: Clear the run time.
Change the setting with the or Key. The S8M
will automatically return to the CLR display if no
key is pressed within 3 s.
When the Key is pressed, the setting will flash
and the setting will be read when the flashing
stops. If “yes” was selected, the run time will be
cleared and the S8M will return to CLR display.
If you want to confirm that the run time was
cleared, read the run time in Run Mode.
If the Down Key ( ) is pressed from the CLR display, the display will
switch to the current tripping value setting (C-V) for branch output 1.
To Next Page
Loading...