Omron S8M - Page 89

71
Special Settings and Communications Settings Section 4-8
Send Wait Time: SWT (Send Wait Time)
The send wait time setting display (SWT) will be displayed if the Down Key
( ) is pressed from the parity setting display (PTY).
Run Time Clear: CLR (Time Clear)
The run time clear display will be displayed if the Down Key ( ) is pressed
from the send wait time setting display (SWT).
s w t
0
1 0
(
Return to SWT dis
p
la
y
.
)
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
This parameter sets the RS-232C port's send wait time.
Switch to the
run time clear
operation.
Press the Key to display the send wait time set-
ting. The setting can be changed by pressing the
and Keys (see note).
The setting range is 0 to 999 ms.
Note If the or Key is pressed for more than 2 s,
the SV will change in 10 ms units instead of 1 ms
units.
Change the setting with the and Keys.
The S8M will automatically return to the SWT
display if no key is pressed within 3 s.
When the Key is pressed, the setting will flash.
When the flashing stops, the new setting will be
saved and the S8M will return to SWT display.
If you want to confirm the new setting, press the
Key again from the SWT display.
If the Down Key ( ) is pressed from the SWT display, the display
will switch to the run time clear display (CLR).
c l r
23
4
°C
kh
V
A
s
1
This operation resets the run time to 0.