3-28
Param-
eter
No.
MemoChan-
ges
during
opera-
tion
Default
setting
Set-
ting
range
DescriptionNameReg-
ister
No.
(Hex)
n105 0169 Torque
com-
pensation
core loss
Sets the core loss of the motor in use.
Note Normally, the default setting does
not need to be changed.
Note This parameter is enabled in V/f
control mode only.
0.0 to
6,550
Varies
with the
capac-
ity.
No
n106 016A Rated
motor slip
Used to set the rated slip value of the
motor in use.
Note Used as the constant of the slip
compensation function or vector
control.
0.0 to
20.0
Varies
with the
capac-
ity.
Yes
Note Speed search deceleration time and speed search operating level can be set for 5.5-kW and
7.5-kW Inverters only.
Param-
eter
No.
Reg-
ister
No.
(Hex)
Name Description Set-
ting
range
Default
setting
Chan-
ges
during
opera-
tion
Memo
n107 016B
Motor
phase-to-
neutral
resis-
tance
Set this parameter to the phase-to-neutral
resistance or 1/2 of the phase-to-phase
resistance of the motor.
Note This parameter is used as a vector
control constant.
0.000
to
65.50
Varies
with the
capac-
ity
No
n108 016C Motor
leakage
induc-
tance
Sets the leakage inductance of the motor
in use.
Note This parameter is used as a vector
control constant.
Note The Inverter with the default setting
in this parameter fully functions in
vector control.
0.00 to
655.0
Varies
with the
capac-
ity.
No
n109 016D Torque
com-
pensation
limit
Sets a limit on the torque compensation
function in vector control mode.
Note Normally, the default setting does
not need to be changed.
Note The Inverter in torque compensation
control limits the torque at a current
1.5 times larger than the set value.
0 to
250
150 No
n110 016E Motor no-
load cur-
rent
Used to set the no-load current of the
motor in use based on the rated motor cur-
rent as 100%.
Note Used as the constant of vector con-
trol and the slip compensation func-
tion.
0 to 99 Varies
with the
capac-
ity
No
List of Parameters Chapter 3
To Next Page
Loading...
