9. Program
72
9.6.
This
corr and error messages
(response for command, unspecified command) are set.
Additional Information
6. Receive Message Setting
section describes the settings of receive messages. The receive messages
esponding to three response formats for a normal message
For details on the settings of the send message, refer to 3-4 Communication Message
Attributes in the CX-Protocol Operation Manual (Cat. No. W344).
[Receive message setting screen]
●
RV_GETRVE re
<Settings>
<
Settings of R ceive message (normal message)
h>
+“GETR”+&(W(1),4)+" "+"typ"+"=""+(W(10),*)+"" "
(5) (6) (7) (8) (1) (2) (3
+"fwv"
) (4)
+"="+&(W(20),3)+"-" +&(W(21),3)+"-"+&(W(22),3)+"-" +&(W(23),1)+<c>+<t>
(10) (11) )
●Settings of RV_GETRERR m
(9) (12 (13) (14) (15) (16) (17) (18) (19)
essage name (error message: response
<Settings>
<h>
+“GETR”+&(W(1),4)+<c>+<t>
(1) (2) (3) (18) (19)
No. Code Description
(1) <h >(Header) Type: Code, Data: 02 Hex
(2) (4) (5)
(6)(8)(9)
(10)(12)
(14)(16)
“GETR”,,””,”typ”,”
="",”"”,”fwv”,”=”,”-“
,”-“,”-“
Constant ASCII
(3) &(W(1),4)
(W(1),4): Converts 4-byte data and stores it in the [first
receive word specified with the PMCR instruction operand
+ 1 word].
&: Forward direction hexadecimal conversion (Converts the
receive message from ASCII code into hexadecimal code,
and outputs the receive data from the lower byte)
(7) (W(10),*)
(W(10),*): Converts *-byte data and stores it in the [first
receive word specified with the PMCR instruction operand
+ 10-word].
To Next Page
Loading...
Need help?
General
