7
EtherNet/IP Connection Procedure
7.2.2. Parameter Settings
Set the parameters for Sensor Controller.
The parameters are set using Sysmac Studio.
Install Sysmac Studio on Personal computer beforehand.
Since Personal computer and Sensor Controller are connected with LAN cables, set the IP
address of Personal computer to 192.168.250.100.
Precautions for Correct Use
The Parameters for Sensor Controller are checked using Ethernet communications with
Personal computer.
Note that there may be some changes required for the Personal computer settings
depending on the state of Personal computer.
1
Turn ON Sensor Controller and
Switching hub.
To Next Page
Loading...
