7
EtherNet/IP Connection Procedure
8
The Select Sensor Dialog Box is
displayed.
Select Specify a sensor and set
the IP address to
192.168.250.50.
Click Confirm.
9
The information of Sensor
Controller and Sensor Head is
displayed. Check that the
information displayed there
indicates the connected devices.
Click OK.
*If Sensor Controller is not
specified, the IP address and
other settings may not be in the
factory default state. Refer to
the Displacement Sensor
ZW-7000 series Confocal Fiber
Type Displacement Sensor
User's Manual (Cat. No. Z362)
to check the values of IP
address and others.
To Next Page
Loading...
